Exmark Ultra Vac User Manual download pdf (Page 10)

3.2 INSTALL DRIVE KIT

1. Install drive kit (PN 103-1313, 103-1314, 103-1315, or 103-1317 depending on deck size)

per the instructions included in the kit.

NOTE: The original belt shield stud must be removed for belt clearance.

3.3 INSTALL HOOD ASSEMBLY AND BAGS

44 and 48 inch units (52 inch units skip to step 3)

Note: When installing Ultra Vac on Lazer Z HP model LHP4818KC with serial numbers below

176621, refer to additional necessary instructions included in adapter kit 103-0328.

1. Remove and discard the (8) bolts that retain the “HOT” engine guard shield (Item 1).

Keep the nuts for use in Step 2.

2. Install the Bagger Mount Weldment (Item 2) and engine guard shield using the 5/16-18 x 1

Screws provided (Item 3) and whizlock nuts removed in step 1. Continue at step 6.

52 inch units

3. Remove and discard the (8) bolts that retain the rear weight (Item 12). Keep the whizlock

nuts for use in step 5.

4. Install the Bagger Mount Weldment (Item 2) to the rear of the frame using (4) 5/16 – 18

X1.00 screws (Item 3) and (4) 5/16 – 18 whizlock nuts (Item 15). Use only the bottom

four holes on the Bagger Mount Weldment

5. Install the Rear Weight (Item 12) and spacer (Item 13) from the drive kit using the (8) 5/16

– 18 X1.75 screws (Item 14) and whizlock nuts removed in step 3.

All units

6. Slide tube ends of Hood Assembly (Item 4) into the tubes of the mount weldment. Install

(2) clevis pins (Item 16) through holes in tubes. Retain with (2) Hair Pins (Item 17).

7. Hang the (2) Bag Assemblies (Item 5) from the slots in the Bagger Upright. Close and

latch hood.

3.4 ASSEMBLE TUBES

Note: When installing Ultra Vac on Lazer Z HP model LHP4818KC with serial number below

176621, refer to additional necessary instructions included in adapter kit 103-0328.

1. Assemble the Upper (Item 6) and Lower (Item 7) Tubes using the (3) #10-24 x .75 Truss

head Screws (Item 8), (3) #10 washers (Item 9), and (3) #10-24 Nyloc Nuts (Item 10). Screw

head should be installed to the inside of the tube to provide minimum obstruction to flow.

Make sure the hole with the arrow on the Upper Tube aligns with the dimple in the Lower

Tube to place the turnout on the Upper Tube in the correct position.

For units with a 44” deck: Slide Upper Tube over Lower Tube until edge of Upper Tube

matches up with dimple in Lower Tube labeled 44.

For units with a 48” & 52” deck: Slide Upper Tube over Lower Tube until edge of Upper

Tube matches up with dimple in Lower Tube labeled 48, 52.

3.5 INSTALL BLOWER ASSEMBLY

1. Remove the belt guide on the blower (Item 11). (See Figure 1)

2. Install the belt (from the Drive Kit) onto the Blower Assembly (Item 11) as shown.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Exmark Ultra Vac User Manual Page 10