Exmark Lazer Z CT User Manual download pdf (Page 22)

Rotate the valve 1/4 turn clockwise to shut off fuel. Rotate the valve 1/4 turn

counter-clockwise to turn on fuel.

3.1.11 Fuel Gauge

: Located on the left fuel tank. The fuel gauge monitors the amount

of fuel in the tank.

3.1.12 Drive Wheel Release Valves

: Located on the right front corner of the hydrostatic

pumps. Drive wheel release valves are used to release the hydrostatic drive

system to allow the machine to be pushed without the engine running. Unhook

seat latch and tilt seat up to gain access to pumps.

With a 5/8 wrench, turn both valves one turn counter-clockwise to release drive

system.

Turn clockwise to reset system. DO NOT overtighten. DO NOT tow machine.

3.2 PRE-START

3.2.1 Fill fuel tank. For best results use only clean, fresh regular grade unleaded gasoline

with an octane rating of 87 or higher. Regular grade leaded gasoline may also be

used; however, combustion chamber and cylinder head will require more frequent

service. See Engine Owner's Manual. DO NOT add oil to gasoline.

Do Not overfill fuel tank. Never fill the fuel tank so that the fuel level rises above a

level that is 1/2” below the bottom of the filler neck to allow for fuel expansion and

prevent fuel spillage.

3.2.2 Make sure you understand the controls, their locations, their functions, and their

safety requirements.

3.2.3 Refer to Maintenance, Section 4, and perform all the necessary inspection and

maintenance steps.

3.3 MOWING

3.3.1 Operate units with the roll bar in the raised and locked position and use seat belt.

There is no rollover protection when the roll bar is down. If it is necessary to lower

roll bar do not wear the seat belt. Raise the roll bar as soon as clearance permits.

3.3.2 Open fuel shut-off valve.

The fuel shut-off valve is located under the seat in the fuel line between the left

fuel tank and the engine.

3.3.3 Starting Engine:

Brake must be engaged, the PTO switch disengaged, and the motion control

levers out (neutral lock position). (The operator does not need to be in the seat

to start the engine.)

On a cold engine, place the throttle midway between the “SLOW” and “FAST”

positions and place the choke to the “ON” position. Turn ignition switch to the

“start” position. Release the switch as soon as the engine starts.

IMPORTANT:

DO NOT crank the engine continuously for more than ten (10)

seconds at a time. If the engine does not start, allow a 60 second cool-down

period between starting attempts. Failure to follow these guidelines can

burn out the starter motor.

After starting a cold engine, gradually return choke to the “OFF” position as the

engine warms up.

On a warm engine, place the throttle midway between the “SLOW” and “FAST”

positions and leave the choke in the “OFF” position.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Comments to this Manuals

No comments

Exmark Lazer Z CT User Manual Page 22

Comments to this Manuals

Related products and manuals for Gardening equipment Exmark Lazer Z CT