Exmark eXmark Ultra VAC Lazer Z User Manual download pdf (Page 19)

- 14 -

FIG. 10

NEUTRAL LOCK

LEVER CLEARANCE

NOTE: Neutral lock/park brake latch clearance should be

checked when there is a slight upward force placed

on the drive levers to remove any "slack" in the

linkage.

After

clevis pin

has been inserted, install hairpin into

hole on the clevis pin

between

the neutral lock/park brake

latch and drive lever (See Figure 11). Repeat procedure on

opposite side of unit.

FIG. 11

Drive Lever Hardware Location

3.8.6 Adjust brakes by adjusting wingnut on the upper end of each

brake rod. Position the wingnut so the brakes will engage

when the drive levers are squeezed enough to place the

neutral lock/park brake latches into the “park brake” position.

NOTE: The neutral lock/park brake latches must be able to be

moved into the park brake position, if not, the brake

linkages must be adjusted again.

3.8.7 Squeeze the drive levers and move both neutral lock/park brake

latches to the rear into the neutral lock position. Mower should

move forward and backward freely, if not, readjust the brakes.

Squeeze the drive levers and move the neutral lock/park brake

latches to the front into the park brake position. Mower should

not move forward and backward freely, if it does, readjust the

brakes.

Drive Linkage

Left Side

Shown

Neutral Lock /

Park Brake Latch

Drive

Lever

Hairpin

Clevis Pin

3/16” TO 1/4”

Drive Linkage

Neutral Lock /

Park Brake Latch

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Comments to this Manuals

No comments

Exmark eXmark Ultra VAC Lazer Z User Manual Page 19

Comments to this Manuals

Related products and manuals for Lawnmowers Exmark eXmark Ultra VAC Lazer Z