Exmark eXmark Ultra VAC Lazer Z User Manual download pdf (Page 27)

- 22 -

either the mower blades are engaged, or the transmission

shifter lever is not in neutral and the operator removes

both hands from the handles, the mower engine

must stop

b) To determine if the OPC is in operating condition,

clear area of bystanders. Run the engine at one-third

throttle, then with the drive levers and neutral lock

latches in the

“park brake”

position

, shift the

transmission into gear and release the OPC levers -

the

engine MUST stop

Again, run the engine at one-third throttle, move the

transmission shifter lever to neutral, engage the blade

clutch and release the OPC levers -

the engine MUST stop

If the mower engine does not stop under any of the

above mentioned conditions, DO NOT OPERATE. Contact your

authorized Exmark service dealer.

•

••

•

It is essential that all Operator Safety

Mechanisms, be in place and in proper

operating condition prior to mowing.

5.1.5 Check Brake and Wheel Drive Linkage Adjustment.

Service Interval: Daily

Refer to Sections 3.8.5 and 3.8.6

. Note any bent linkage or

hardware which may need servicing or replacing.

5.1.6 Check for loose hardware.

Service Interval: Daily

a) Stop engine and remove spark plug wire(s).

b) Visually inspect machine for any loose hardware or any

other possible problem. Tighten or replace any hardware

before operating.

5.1.7 Service pre-cleaner element and air cleaner.

Service Interval: See Engine Owners Manual

a) Stop engine and remove spark plug wire(s).

b) See engine owners manual for cleaning instructions.

5.1.8 Change engine oil.

Service Interval: See Engine Owner's Manual

NOTE: Change oil after first five (5) hrs. of operation. Follow

engine manufacturer's recommendations for future oil changes.

a) Disengage blades.

b) Stop engine and remove spark plug wires(s).

c) Drain oil while engine is

warm

from operation or if oil

is to be changed after the unit has been sitting for

awhile, run engine for a few minutes to get it warm.

•

••

•

Do Not

service or make repairs near the

engine area when the engine is

hot

d) Remove the oil drain plug from the right hand side of

the engine. Allow oil to drain, replace drain plug.

e) Replace the oil filter per the engine owners manual

(Kohler and Kawasaki only, there is no filter on B&S

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Comments to this Manuals

No comments

Exmark eXmark Ultra VAC Lazer Z User Manual Page 27

Comments to this Manuals

Related products and manuals for Lawnmowers Exmark eXmark Ultra VAC Lazer Z