Exmark eXmark Ultra VAC Lazer Z User Manual download pdf (Page 20)

- 15 -

3.8.8 Route the long, unattached wiring harness lead up the left

hand side of the handle and connect the two leads, in any

order, to the operator presence control switch terminals on

the inside of the control console. Fasten the lead to the

handle with two large wire ties, from bolt bag, one at the

upper end of the handle next to the console and one at the

very lower end of the handle where it attaches to the fuel

tank support.

3.9 If the unit is shipped without the muffler attached, install

with hardware provided.

3.10 Service Engine: Follow the recommendations in the Engine

Operators Manual.

3.11

Grease unit.

NOTE: UNIT IS NOT GREASED AT THE FACTORY! Refer to Section

5.1.12 for locations and grease amounts.

3.12 Follow pre-start instructions as outlined in Section 4.2.

4. OPERATION INSTRUCTIONS

4.1 CONTROLS

4.1.1 Familiarize yourself with the controls and operation of the

unit.

Carefully read the following information about the controls

and their operation.

4.1.2 Drive Levers:

Located on each side of the upper handle assembly directly

below the handle grips. These levers individually control

clutching action of the wheel drive belts and brakes. When

the drive levers are all the way down, the wheel drive belts

engage and the brakes disengage. Squeezing the left or right

hand drive lever causes the left hand or right hand wheel to

slow down or stop, which makes the machine turn to the left

or right respectively. The sharpness of the turn varies by

how much the lever is squeezed. If both levers are squeezed

all the way back, both brakes will engage and the machine

will stop. For straight ahead motion, smoothly release both

drive levers to engage both drive wheels simultaneously.

4.1.3 Neutral Lock/Parking Brake Latches:

Located directly above the drive levers. The purpose of these

latches is to allow the operator to lock the drive levers in a

"neutral" position where neither the wheel drive belts nor the

brakes engage or in a “park brake” position where the wheel

drive belts are not engaged and the park brake is engaged. To

lock the drive levers in neutral, squeeze the drive levers back,

place thumbs on the upper portion of the neutral lock/park brake

latches and move them to the rear. Release drive levers. To

lock the drive levers in “park brake” position, squeeze the

drive levers back, place thumbs on the upper portion of the

neutral lock/park brake latches and move them ahead. Release

drive levers as stated in 4.1.2. (See Figure 12).

Apply parking brakes whenever leaving the operators position.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Comments to this Manuals

No comments

Exmark eXmark Ultra VAC Lazer Z User Manual Page 20

Comments to this Manuals

Related products and manuals for Lawnmowers Exmark eXmark Ultra VAC Lazer Z