Exmark eXmark Ultra VAC Lazer Z User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
- 2 -
Fuel is
Highly Flammable. DO NOT
smoke
while refueling. Refuel only in a well
ventilated area, or refuel outdoors.
Store fuel in containers specifically
designed for this purpose.
Add fuel before starting the engine.
Never
remove the cap of the fuel tank
or add fuel when engine is running or
when the engine is hot.
Never fill the fuel tank so that the fuel
level rises above a level that is 1/2” below
the bottom of the filler neck to allow for
fuel expansion and prevent fuel spillage.
If fuel is spilled,
DO NOT
attempt to start
the engine. Move away from the area of the
spill and avoid creating any source of
ignition until fuel vapors have dissipated.
1.4 OPERATION
1.4.1 Give complete, undivided attention to the job at hand.
1.4.2 Mow only in daylight or in good artificial light.
DO NOT
operate the mower when children or others are in the area.
1.4.3 When feasible, avoid operating the equipment in wet grass.
1.4.4 Use
EXTREME
caution when mowing and/or turning on slopes as
loss of traction and/or control could occur. Mow
across
slopes
with walk behind mowers, never up and down. Loss of control
and/or loss of operator’s footing could result in a fall with
an arm or leg getting under the mower or engine deck and
sustaining serious injury. Drive slower on slopes.
DO NOT
operate on slopes greater than 20 degrees. Watch for ditches,
holes, rocks, dips, and rises which can cause erratic
handlebar movement and loss of footing. Keep away from drop-
offs and steep banks. Avoid sudden starts. Look down and
behind you before and while moving backwards.
DO NOT
mow
slopes when grass is wet - slippery conditions create
hazardous footing, affect steering, and reduce traction and
braking. The operator is responsible for safe operation on
slopes. See inside back cover to determine the approximate
slope angle of the area to be mowed.
1.4.5 Stop the blades when crossing surfaces other than grass,
if mower must be tilted for transportation, and when
transporting the mower to and from the area to be mowed.
1.4.6 Never operate the mower with defective guards, shields, or
covers. Always have safety shields, guards, switches, and
other devices in place and in proper working condition.
1.4.7
Do Not
change the engine governor settings or overspeed
the engine. Operating an engine at excessive speed may
increase the hazard of personal injury.
1.4.8 Place transmission in neutral, disengage blades, and latch
drive levers in “park brake” position before starting engine.
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comments to this Manuals

No comments