Exmark eXmark Ultra VAC Lazer Z User Manual download pdf (Page 17)

- 12 -

For B&S 8.5 hp Engines,

a) Position the throttle control lever (on console)

1/8" from the lower end of the slot. Route the

throttle cable along the right side of the upper

handle, under the fuel tank support, and position

the cable on the left side of the engine.

b) Attach the inner wire to the appropriate throttle

control slider on the engine. Loosen the cable

clamp on the engine, place the cable behind it and

push ahead on the cable to move the throttle

linkage to the "stop" position. Tighten the cable

clamp screw.

3.8.2 Attach the fuel tank hose to the tank fitting and

secure with the clamp provided.

3.8.3 Install the blade engagement linkage to the bell crank

on the

Left Hand

side of the engine deck. Insert rod

through the hole from the outside and fasten with

cotter hairpin.

3.8.4 Install and adjust shifter lever.

a) Remove the 3/8" nyloc nut and spring disc washer from

the stud on top of the transmission. Install the

shifter lever through slot in shifter lever plate

and onto the stud on top of transmission. Be sure

the square-hole washer remains between the lever

and transmission. Replace the spring disc washer and

nyloc nut (See Figure 6). Torque the 3/8" nut to

35 ft. lbs. (47 N

⋅

m).

b) Shift lever to second gear and check alignment of

lever in slot of shifter plate. Clearance between

top of lever and the top of the slot should be

about equal to the clearance between bottom of the

lever and the bottom of the slot (See Figure 7).

If it is not, remove lever and bend it slightly to

adjust.

DO NOT

bend lever while it is attached to

transmission. Reinstall lever and tighten hardware.

c) Shift to neutral position. Lever should not contact the

left edge of the upper slot. Push lever down. Lever

should not contact the right edge of the bottom slot

(See Figure 8). Shifter plate can be adjusted

ide to

side to adjust position of lever relative to the slot in

plate. Loosen the two bolts securing the shifter plate

to the shifter lever legs. Adjust shifter plate and

retighten bolts.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Comments to this Manuals

No comments

Exmark eXmark Ultra VAC Lazer Z User Manual Page 17

Comments to this Manuals

Related products and manuals for Lawnmowers Exmark eXmark Ultra VAC Lazer Z